Directions
1)
Be sure that you have a flat, surface on which
to work.
2)
Put a piece of masking tape on one end of your
string and set aside. This will close one end
of your string and keep the beads from falling
off while stringing.
3)
Layout the design of your bracelet on your bead
mat, then start stringing your beads onto the
cording.
The order of the beads is as follows:
troop numbers, clear, light blue, yellow, clear,
lime green, red, clear, oragne, purple, clera,
hot pink, green, clear, pink, violet, clear.
4)
When you finish stringing all your beads, tie
a double knot to finish your bracelet. Make your
knot is nice and tight, tug on the ends to be
sure.
5)
Once your knot is tightened, use scissors to cut
off the extra string.
|
